Hi All,
Does anyone know any information about GCM weight capacity for a Volvo B6FA? I have a 1984 Custom coach Volvo that has recently been fitted out as a motorhome. I want to get a towbar fabricated, but the fabrication shop were unable to proceed as they said they needed the GCM (Gross Combination Mass) value which was not printed on the original compliance plates. The issue the fabricator had was the cut chassis behind the rear wheel to a sub chassis to accommodate the boot, and whether this has a load bearing capacity, also the capacity of the engine/gearbox to handle a load. I have tried multiple times to get an answer from Volvo but seem to get the run around from one person to another with no answers. Has anyone been down this road before and have some helpful advice please.
Regards,
Damien
Towbar fabrication for Volvo B6FA
Moderator: MAN 16.242
Forum rules
### This section is a NO FLAMING ZONE! That means you cannot reply "harshly", abusively, sarcastically or in any negative manner to members. ###
### This section is a NO FLAMING ZONE! That means you cannot reply "harshly", abusively, sarcastically or in any negative manner to members. ###
- boronia
- Posts: 21589
- Joined: Sat Mar 06, 2004 6:18 am
- Favourite Vehicle: Ahrens Fox; GMC PD4107
- Location: Sydney NSW
Re: Towbar fabrication for Volvo B6FA
I believe that the B6FA had a GVM around 12 tonne; presumably a bus chassis would not normally need a GCM rating.
You might need a qualified auto engineer to come up with design to meet your circumstances.
You might need a qualified auto engineer to come up with design to meet your circumstances.
Preserving fire service history
@ The Museum of Fire.
@ The Museum of Fire.
Re: Towbar fabrication for Volvo B6FA
Thank you
I found an engineer to give me the design and certification. Only problem is that he wants to extend the chassis through the boot to come down to the subchassis. If I didn't have a water tank and washing machine in the way I might have done the work.
I found an engineer to give me the design and certification. Only problem is that he wants to extend the chassis through the boot to come down to the subchassis. If I didn't have a water tank and washing machine in the way I might have done the work.
-
- Posts: 0
- Joined: Mon May 27, 2019 7:02 pm
Re: Towbar fabrication for Volvo B6FA
I've just been to a very reputable towbar and exhaust dealers in Mandurah and any towbar built for a vehicle pre 1987 does not need to be certified
Re: Towbar fabrication for Volvo B6FA
Just wanted to know how you went getting a towbar as I am wanting to fit one to my b6fa also.