K280UB - #336
Forum rules
- A topic icon must be used with the thread title of all threads.
- No more than 10 photos per post with a maximum of 50 in any one page in a thread.
- Maximum photo width 1000 pixels.
- For full photo rules and how to attach photos see viewtopic.php?f=10&t=28459
- Thank you
8 posts
• Page 1 of 1
K280UB - #336
by Tas Bus Nut » Fri Feb 17, 2012 9:02 pm
#336 - Scania K280UB - CC CB60 Evo.II
Next TBCS event - Sunday May 26 > Maritime Museum + BBQ lunch
RSVP yoda by May 23 - Bus departs Springfield 12noon - (Cost $10)
RSVP yoda by May 23 - Bus departs Springfield 12noon - (Cost $10)
-
Tas Bus Nut - Posts: 7847
- Joined: Sun Oct 05, 2008 9:08 pm
- Location: Hobart Tasmania
- Has thanked: 23 times
- Been thanked: 265 times
- Favourite Vehicle: Mercedes Benz O303
Re: K280UB - #336
by vernbale » Fri Feb 17, 2012 10:46 pm
At least the desto uses all the LED board, a lot of our destos on 330 and 331 use about 2/3 of the LED board, looks CR#P 
TRAINS - LOVE the POWER and SOUND
-
vernbale - Posts: 2181
- Joined: Sat Oct 16, 2010 4:31 pm
- Location: Launceston
- Has thanked: 23 times
- Been thanked: 14 times
- Favourite Vehicle: Scania N113 Orana's, TRAINS
Re: K280UB - #336
by metro_tas » Sat Feb 18, 2012 8:09 am
all scrunched up in the left hand corner vern?
-
metro_tas - Posts: 1966
- Joined: Thu Dec 13, 2007 9:45 pm
- Location: Hobart
- Has thanked: 0 time
- Been thanked: 2 times
- Favourite Vehicle: Anything volvo or leyland
Re: K280UB - #336
by vernbale » Sat Feb 18, 2012 9:14 am
metro_tas wrote:all scrunched up in the left hand corner vern?
Yes!, why can't they program it better
TRAINS - LOVE the POWER and SOUND
-
vernbale - Posts: 2181
- Joined: Sat Oct 16, 2010 4:31 pm
- Location: Launceston
- Has thanked: 23 times
- Been thanked: 14 times
- Favourite Vehicle: Scania N113 Orana's, TRAINS
Re: K280UB - #336
by Tas Bus Nut » Sat Feb 18, 2012 9:54 am
Ours sometimes still seem a little to the left. However YOUR problem (according to the programmer upstairs) is the program is based on the flipdot desto, NOT the LED desto 
Down here, we have TWO different flashdrives, one for LED & the other flipdot. We had a problem here too, when the electricians put the wrong flash in the module and the writing came out very small and to the left. Simple fix. I'll enquire upstairs on Monday and see if they can fix it 4 U. (U R right, it DOES look absolute SH#T 
and difficult to read IMO)
Down here, we have TWO different flashdrives, one for LED & the other flipdot. We had a problem here too, when the electricians put the wrong flash in the module and the writing came out very small and to the left. Simple fix. I'll enquire upstairs on Monday and see if they can fix it 4 U. (U R right, it DOES look absolute SH#T and difficult to read IMO)Next TBCS event - Sunday May 26 > Maritime Museum + BBQ lunch
RSVP yoda by May 23 - Bus departs Springfield 12noon - (Cost $10)
RSVP yoda by May 23 - Bus departs Springfield 12noon - (Cost $10)
-
Tas Bus Nut - Posts: 7847
- Joined: Sun Oct 05, 2008 9:08 pm
- Location: Hobart Tasmania
- Has thanked: 23 times
- Been thanked: 265 times
- Favourite Vehicle: Mercedes Benz O303
Re: K280UB - #336
by CB80 » Sat Feb 18, 2012 12:19 pm
Yes the LED's have a higher resolution than the flipdot destos, so when the flipdot file is loaded it only covers a certain amount of the panel, giving the result seen above.
-
CB80 - Posts: 3487
- Joined: Sat Aug 13, 2005 5:13 pm
- Location: Melbourne.
- Has thanked: 103 times
- Been thanked: 118 times
- Favourite Vehicle: Leyland Tiger
Re: K280UB - #336
by vernbale » Sat Feb 18, 2012 10:24 pm
Thanks, that explains it, sure be good to get the right LED program 
TRAINS - LOVE the POWER and SOUND
-
vernbale - Posts: 2181
- Joined: Sat Oct 16, 2010 4:31 pm
- Location: Launceston
- Has thanked: 23 times
- Been thanked: 14 times
- Favourite Vehicle: Scania N113 Orana's, TRAINS
8 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests