• Advertisement

Need advice on insulation blp2

Discussions regarding bus to motorhome conversions are welcome here.

Need advice on insulation blp2

Postby Gregg » Thu Feb 13, 2020 4:15 am

Hi everyone I have a Bedford blp2 1978 comair body. And have started to pull interior roof and walls for insulation. I have seen lots off peoples videos tutorials and blogs. Please excuse if this has been covered but I haven’t seen it. From the bottom of my window till the floor is covered with metal sheeting on top of the rails making it impossible to insulate it with batts like I’m going to to from Dotcom off windows up and roof.was wondering what I should do
1 don’t put any type of insulation on that section
2 use the silver type paper / thing cardboard type
3 cut a hole into the cavity and spray insulation in.
4 open to suggestions
I would just like to say thanks in advance greatly appreciate everyone sharing thoughts ideas etc
User avatar
Gregg
 
Posts: 2
Joined: Mon Oct 16, 2017 9:48 pm
Location: Denmark Western Australia
Has thanked: 0 time
Been thanked: 0 time
Favourite Vehicle: Bedford blp

Re: Need advice on insulation blp2

Postby csrbd » Fri Feb 14, 2020 7:32 am

Gday
I was advised not to use batts for the insulation as they have the potential to hold moisture. I removed the lower sections under the windows and used 30mm foil backed polystyrene sheets which allowed a 20mm air gap. I replaced with 5mm plywood and painted.
csrbd
 
Posts: 47
Joined: Wed Feb 03, 2010 1:35 pm
Has thanked: 0 time
Been thanked: 1 time

Re: Need advice on insulation blp2

Postby stajourneyman » Tue Mar 10, 2020 6:33 pm

Are you sure your bus has a Comair body.

There were a few of them made around 1978 when Comair resumed building bus bodies again briefly.

However if that is a photo of your bus, it would be an Ansair body of the same vintage.
stajourneyman
 
Posts: 1314
Joined: Sat Dec 16, 2006 9:43 pm
Has thanked: 19 times
Been thanked: 72 times

Re: Need advice on insulation blp2

Postby stajourneyman » Tue Mar 10, 2020 6:33 pm

Are you sure your bus has a Comair body.

There were a few of them made around 1978 when Comair resumed building bus bodies again briefly.

However if that is a photo of your bus, it would be an Ansair body of the same vintage.
stajourneyman
 
Posts: 1314
Joined: Sat Dec 16, 2006 9:43 pm
Has thanked: 19 times
Been thanked: 72 times



  • Advertisement

Return to Bus to motorhome discussions

Who is online

Users browsing this forum: No registered users and 1 guest