K280UB - #336

[Tas Bus Nut]

#336 - Scania K280UB - CC CB60 Evo.II

[vernbale]

At least the desto uses all the LED board, a lot of our destos on 330 and 331 use about 2/3 of the LED board, looks CR#P

[yoda]

Just do the Hobart thing and book it up!

[metro_tas]

all scrunched up in the left hand corner vern?

[vernbale]

all scrunched up in the left hand corner vern?

Yes!, why can't they program it better

[Tas Bus Nut]

Ours sometimes still seem a little to the left. However YOUR problem (according to the programmer upstairs) is the program is based on the flipdot desto, NOT the LED desto Down here, we have TWO different flashdrives, one for LED & the other flipdot. We had a problem here too, when the electricians put the wrong flash in the module and the writing came out very small and to the left. Simple fix. I'll enquire upstairs on Monday and see if they can fix it 4 U. (U R right, it DOES look absolute SH#T and difficult to read IMO)

[CB80]

Yes the LED's have a higher resolution than the flipdot destos, so when the flipdot file is loaded it only covers a certain amount of the panel, giving the result seen above.

[vernbale]

Thanks, that explains it, sure be good to get the right LED program